What This Is

This listing is for a 2-pack of tilt cylinder seal kits for the Massey Ferguson 232 front-end loader, Massey Ferguson part number 837393M91. You receive two complete kits in one purchase. Each kit contains the seals and O-rings used to rebuild and reseal one loader tilt cylinder, the cylinder that curls and dumps the bucket. Over years of service the rod seal and piston seal wear and the cylinder begins to leak down, letting the bucket drift or lose holding power. Resealing with a fresh kit restores firm, controlled bucket action without the cost of a new cylinder.

Fitment

These kits fit the hydraulic tilt (bucket) cylinder on the Massey Ferguson 232 loader. The 232 is a front-end loader that was offered on Massey Ferguson 200 Series utility tractors of the late 1980s and 1990s, such as the MF 253. Because loaders of this family were sold over a long run and cylinders were updated, fitment is best confirmed at the cylinder rather than by tractor model. Match the kit to cylinder number 1063099M91 and to a cylinder with a 1-1/4 inch rod and a 2 inch bore. If you are unsure, measure your rod and bore and check your cylinder casting number before ordering.

Specifications

The kit is built for a tilt cylinder with a 1-1/4 inch (1.25 in) rod diameter and a 2 inch bore. It includes the rod seal, piston seal, O-rings, rod wiper, and back-up rings needed to fully reseal that cylinder. These are standard reseal components for a hydraulic tilt cylinder of this size.

What Is Included

Two (2) complete 837393M91 tilt cylinder seal kits. That is enough to reseal two tilt cylinders, or to reseal one cylinder now and keep a full spare kit on hand. The kits ship as loose seal sets; the loader cylinder, rod, and piston are not included.

Cross-Reference

This is a direct replacement for Massey Ferguson OEM seal kit 837393M91 for the 232 loader tilt cylinder (host cylinder 1063099M91). It is a new aftermarket seal kit, not a used or OEM-boxed part. Any OEM numbers are listed for reference only to help you identify the correct kit.

Ordering Guidance

Seal kits are cylinder-specific, and Massey Ferguson revised some loader cylinders over the production run. Before ordering, confirm two things: that your cylinder is the 1063099M91 tilt cylinder on a 232 loader, and that your rod is 1-1/4 inch and your bore is 2 inch. Older cylinders can use a different seal arrangement, so if your cylinder does not match these dimensions, this kit may not contain the correct pieces. When the measurements match, this 2-pack gives you everything needed to reseal two tilt cylinders.